8-26
Messages displayed on lower line
On-screen message Description Action
Proc Missing Processor is not found.
240VA Power Down POWERGOOD dropped during power-on.
Power On Cnt Alm POWERGOOD signal error occurred at power on/off.
Proc1 VccpAlm XX VCCP voltage alarm occurred on processor #1.
Proc2 VccpAlm XX VCCP voltage alarm occurred on processor #2.
Proc3 VccpAlm XX VCCP voltage alarm occurred on processor #3.
Proc4 VccpAlm XX VCCP voltage alarm occurred on processor #4.
BB +3.3v Alm XX +3.3V voltage alarm occurred on I/O board.
BB +3.3vs Alm XX +3.3Vs voltage alarm occurred on I/O board.
BB +5.0v Alm XX +5.0V voltage alarm occurred on I/O board.
BB +5.0vs Alm XX +5.0Vs voltage alarm occurred on I/O board.
BB +12v Alm XX +12V voltage alarm occurred on I/O board.
BB -12v Alm XX -12V voltage alarm occurred on I/O board.
VBAT Alm XX Voltage alarm in lithium battery occurred.
BB +1.25v Alm XX +1.25V voltage alarm occurred on I/O board.
BB +1.5v Alm XX +1.5V voltage alarm occurred on I/O board.
BB +1.8v Alm XX +1.8V voltage alarm occurred on I/O board.
BB VTT Alm XX +1.150V voltage alarm occurred on I/O board.
VDD TNB Alm XX +1.500V voltage alarm occurred on processor board.
VCACHE1 Alm XX VCACHE1 voltage alarm occurred on processor board.
VCACHE2 Alm XX VCACHE2 voltage alarm occurred on processor board.
Proc 1 T-Trip Thermal Trip occurred on processor #1.
Proc 2 T-Trip Thermal Trip occurred on processor #2.
Proc 3 T-Trip Thermal Trip occurred on processor #3.
Proc 4 T-Trip Thermal Trip occurred on processor #4.
Processor 1 IERR IERR occurred on processor #1.
Processor 2 IERR IERR occurred on processor #2.
Processor 3 IERR IERR occurred on processor #3.
Processor 4 IERR IERR occurred on processor #4.
SB1 +3.3v Alm XX +3.3V voltage alarm occurred on SCSI backplane 1.
SB1 +5.0v Alm XX +5.0V voltage alarm occurred on SCSI backplane 1.
SB1 +12v Alm XX +12V voltage alarm occurred on SCSI backplane 1.
SB2 +3.3v Alm XX +3.3V voltage alarm occurred on SCSI backplane 2.
SB2 +5.0v Alm XX +5.0V voltage alarm occurred on SCSI backplane 2.
SB2 +12v Alm XX +12V voltage alarm occurred on SCSI backplane 2.
SCSI A-1 Alm XX SCSI channel-A voltage error occurred.
SCSI A-2 Alm XX SCSI channel-A voltage error occurred.
SCSI A-3 Alm XX SCSI channel-A voltage error occurred.
SCSI B-1 Alm XX SCSI channel-B voltage error occurred.
SCSI B-2 Alm XX SCSI channel-B voltage error occurred.
SCSI B-3 Alm XX SCSI channel-B voltage error occurred.
Proc1 TempAlm XX Processor #1 thermal error occurred.
Proc2 TempAlm XX Processor #2 thermal error occurred.
Proc3 TempAlm XX Processor #3 thermal error occurred.
Proc4 TempAlm XX Processor #4 thermal error occurred.
BB Temp Alm XX I/O board thermal error occurred.
FP Temp Alm XX Front panel thermal error occurred.
OS shutdown Alm Operating system shutdown alarm occurred.
WDT timeout Watchdog timer timeout error occurred.
DUMP Request! Dump switch is pressed.
SMI timeout SMI timeout occurred.
AC lost Alm 1 AC lost occurred on power unit #1.
AC lost Alm 2 AC lost occurred on power unit #2.
AC lost Alm 3 AC lost occurred on power unit #3.
AC lost Alm 4 AC lost occurred on power unit #4.
Contact your service representative.
To Next Page
Loading...
