8-36
Event logs in using SNMP Service in Windows Server 2003
Event Type: Warning
Event Source: EvntAgnt
Event Category: None
Event ID: 1015
Description: TraceLevel parameter not located in registry;
Default trace level used is 32.
Event Type: Warning
Event Source: EvntAgnt
Event Category: None
Event ID: 1003
Description: TraceFileName parameter not located in registry;
Default trace file used is.
→ The system will not be affect by these event logs. SNMP will not be affected either, so that you can
ignore these logs.
A PCI board is not recognized.
• Is the PCI board installed correctly?
→ Confirm that the PCI board is installed in the slot correctly.
• Is the proper IRQ assigned for the board?
→ Assign the proper IRQ by referring to the Chapter 4.
• Is "Disabled" specified in [Option ROM] for the slot to install SCSI card (excluding the array board used
for operating system boot)?
→ Check the settings with the BIOS setup utility.
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>
• Is "Disabled" specified in [Option ROM] for the slot for added network board which is not used for
network boot?
→ Check the settings with the BIOS setup utility.
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>
PCI hot-plug fails:
• Is BIOS configuration correct?
→ You must change the BIOS configuration to use the PCI hot-plug feature.
<Menus to check: [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] -
[Minimum/Middle/Maximum*]>
* Setting value depends on the board to be installed. See Chapter 4 for details.
<Menus to check: [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] - [Empty Bus Default
Speed] - [PCI Slots 5-6] or [PCI Slots 7-8] - Transfer speed of the board to be installed>
The driver of a PCI board cannot be stopped from the operating system when Hot Remove or Hot Replace is executed
for the PCI board:
• Is another software application using the PCI board for which Hot Remove or Hot Replace is to be
executed?
→ If another software application is using the PCI board for which Hot Remove or Hot Replace is to be
executed, the driver of the PCI board cannot be stopped.
Terminate the software, then stop the driver of the PCI board. If executing Hot Replace, restart the
software after having mounted a new PCI board.
To Next Page
Loading...
