9-36
NOTES:
After g board, secure it with the lock on the upper part of the guide rail. installed the lon
the PCI board slots.
d already been installed. Take care not to remove o
removing the PCI board. If the insulator is taken of
The insulators are installed between
They are for protecting the PCI boar r
damage the insulator when installing or f,
reinstall the insula
tor in place.
6. Connect the c
7. Slowly close
8. Press the PCI hot plug switch.
e
ables to the PCI board while firmly holding the PCI board with your hand.
the tab to secure the PCI board.
Th PCI Slot Power lamp flashes once, and then goes on.
NOTES:
If the server runs on Windows Serve
automatically recognizes the additiona
If an error occurred in the installed board o er).
r 2003 or Windows 2000, the operating system
lly installed PCI board and installs the driver.
r slot, the PCI Slot Fault lamp goes on (amb
9. Reinstall the PCI slot cover and place the server into the rack.
10. Take the check if the additionally installed PCI board is recognized and operating properly:
(1) Sele , [Administrative Tools], [Computer Management], and [Device Manager] in the order to
start
(2) Move the
following steps to
ct [Control Panel]
the Device Manager.
cursor to the added board.
To Next Page
Loading...
