9-51
Installation
T eps to install the processor. ake the following st
IMPORTANT:
T y sensitive to static electricity. Make sure to touch the metal frame of
t tic electricity from your body before handling the processor. Do not
touch
notes,
When
the P
Install the
T
he processor is extremel
he server to discharge sta
the processor pins by a bare hand or place the processor directly on the desk. For static
see the section "Anti-static Measures" described earlier.
using the server with the single processor configuration, processor must be installed on
rocessor #1.
processor in the ascending order of the processor number (see figure above).
o maintain the cooling effect in the server, install the dummy cover to the empty slot.
1. See the s o
2. Unlock t r
3. Remove the memory slot cover.
4. m
5. m
6. c oing to install processor, remove four screws, then remove the dummy
v
ecti n "Preparing for Installation and Removal" described earlier to prepare.
he f ont bezel with the security key, and remove the front bezel.
Re ove the processor slot cover.
Re ove the memory board.
Lo ate the processor socket which you are g
co er from the socket.
7. Remove the protective cover from the socket surface.
8. Raise the locking lever on the socket.
IMPORTANT: Open the lever until it stops. es.
It can be opened to approx. 120 degre
To Next Page
Loading...
