2-29
IMPORTANT: If a noisy sound in driving the CD-ROM drive occurs after setting a CD-ROM, set
it again correctly.
To take out the CD-ROM from the CD-ROM drive, press the CD tray eject button in the similar way in setting the CD-ROM to
make t
o
A
When button and take out the CD-ROM from the server, follow the
p
pin of approximately 1.2 mm in diameter and 100 mm in length (a straightened large paper clip will
k the
y
he tray go out. (If the access lamp is lit in orange, the CD is being accessed and CD tray eject button is disabled.) Some
perating systems have a command to eject a tray.
fter taking out the CD-ROM, return the tray into the drive.
you fail to eject the CD-ROM tray with the CD tray eject
rocedure below.
1. Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2. Insert a metal
ma e a substitute) into the emergency hole on the upper front of the CD-ROM drive and gently push it in until
tra is ejected.
IMPORTANT:
Do not use a toothpick or plas
If the above procedure does n
representative.
tic stick that is easy to break.
ot let you take out the CD-ROM, contact your service
3. Hold the tray and pull it out.
4. Take out
5. Push the
the CD-ROM.
tray back into position.
To Next Page
Loading...
