“Confidential, Do Not Duplicate without written authorization from NEC.”
6-9
METHOD OF FIRMWARE UPGRADING
10. Common setting
When adjusting the projector, insert the specified USB memory, without fail, in the USB terminal of the
projector before starting operation.
10-1. Lamp off mode (Remote controller operation)
1) In the state of standby, keep pressing the + keys for ten seconds.
2) A display below is presented in the LCD screen. Select “Yes” and press the key.
4) SOURCE / PCF / SCREEN / TGA FILE / MCGD FILE update
Select the “nc16_V*FactoryC.txt” file.
en
CTL
PIXEL
ENTER
3) Turn the power supply ON from the remote controller or the key of the projector main body.
Caution) The Lamp Off mode is canceled when the power supply is turned OFF.
To make the power supply turned ON again in the Lamp Off mode, follow the steps of 1)
to 3) above.
Press the button.
* The “nc16_V*FactoryC.txt” file automatically writes the SOURCE / PCF / SCREEN / TGA File / MCGD
file in the projector.
* Before the replacement of an interface board or if no replacement is intended: A set of TI setup data
Select [ne16_V*ServiceC.txt] of [NC1600_Service_Vx].
To Next Page
Loading...
