23
3. Projection of Images (Basic Operation)
3-3. Selecting the title of input signal
This projector allows you to select pre-registered signals using the signal selection buttons on the control panel (up to 8
signals). Request your dealer/distributor for details on registering and changing titles. This section explains the steps for
selecting registered signals.
1
Turn on the power to the image devices connected to the projector.
2
Press the MENU button.
3
Press the [MENU CTL] LEFT/RIGHT button to display “Title Select” on the LCD screen.
At each press of the [MENU CTL] LEFT/RIGHT buttons, the display will cycle as “Title Select” ←→ “Configuration” ←→
“(Title Setup)” ←→ “Information.”
4
Press the [MENU CTL] DOWN button.
The title of the input signal is displayed.
• When you have made a wrong selection, press the [MENU CTL] UP button. A return will be made to the previous
menu.
5
Press the [MENU CTL] LEFT/RIGHT buttons to display “Title of Signal to be Projected” on the LCD
screen.
6
Press the ENTER button.
The title of the signal to be projected is selected.
• The (*) mark on the LCD indicates that this is the currently selected item.
To Next Page
Loading...
