“Confidential, Do Not Duplicate without written authorization from NEC.”
6-2
METHOD OF FIRMWARE UPGRADING
2. Environmental setup (common)
1) Make connections toward the PC projector through the LAN cable.
2) Start equipment in Lamp Off mode. (Refer to 10-1. Lamp Off Mode.)
3. Error status check
1) Start “DLP Cinema® Control Program” from the PC for login.
(Refer to 10-3. DLP Cinema® Control Program.)
2) Select the “Sys-Status” tab and check the status.
Disregard the failures of Self-Test because they are automatically cleared at the time of updating.
If there is any error, turn off the projector power supply once and confirm that the Interface Board, the
Processor Board, the FFIB Board, and the wiring cables (between FFIB and FSB) are certainly installed.
Caution) If there is any failure relating to Self-Test after updating, there lies a certain problem. In this
case, an adequate measure has to be taken separately.
To Next Page
Loading...
