NEC NC1600C - Turning on the Projector; START Screen

9
2. Operating the Projector Using the Touch Panel
2-3. START Screen
When the touch panel is activated or when you press the [START] button from the menu bar, the START screen is displayed.
With the START menu, you can switch the projector head power ON/OFF (Standby), and the menu mode.
2-3-1. Turning on the Projector
Preparation: Check that there is AC power being supplied to the lamp power unit (only on the NC2500 series) and the projector
head.
If you are using the projector head with the NC800 series, check that the touch panel and AC power adapter are
connected.
1
Turn on the main power switch of the lamp power unit (NC2500 series only).
2
Turn on the main power switch of the projector.
If using a NC2500/NC1500 series projector, the power to the touch panel will turn on by turning on the main power switch
(standby) to the projector head.
If using a NC800 series projector, the power to the touch panel will turn on by turning on the main power switch (standby)
to the projector head and supplying power to the AC power adapter.
After a while, the software is started and the START screen below is displayed.
3
Press the [ON] button in the “POWER” area of the START screen.