“Confidential, Do Not Duplicate without written authorization from NEC.”
6-10
METHOD OF FIRMWARE UPGRADING
10-2. DLP Cinema® Firmware Installation Program
Preliminary arrangements (Not required if setting is already finished in the PC)
Make settings for the PC network to the figures specified below.
IP-Address 192. 168. 010. 17
Gateway 192. 168. 010. 17
Subnet Mask 255. 255. 255. 0
1) Start “DLP Cinema® Firmware Installation Program” from the PC.
Caution) Use the version program attached to the latest release, without fail.
2) Setting for the projector being connected
Enter the IP address of 192. 168. 10. 11.
Select Ethernet Port
Enter IP Address
192.168.10.11
3) Select the connecting port.
Select the Ethernet port.
To Next Page
Loading...
