“Confidential, Do Not Duplicate without written authorization from NEC.”
6-16
METHOD OF FIRMWARE UPGRADING
3. Data updating (Projector “MENU CTL” key operation)
1) Turn the power switch ON while the key is kept pressed.
2) When the Status LED is turned green, press the key.
3) Press the key.
12 3
CANCEL
CANCEL
MENU
POWER SW
+
CANCEL
CANCEL MENU
LCD Display
Data being updated End of data update
Data Update
∗
Data Update
Completed
4) Turn the power switch OFF and pull out the Compact Flash memory.
Caution) Failure in updating: Power LED blinking in red
⇒⇒
⇒⇒
⇒ Retry updating.
After the completion of firmware and data updating, let the projector to assume the “Standby” status.
According to “Information → Version” of the LCD menu, check versions for the following three items:
- BIOS
- Firmware
- Data
To Next Page
Loading...
