NEC NC1600C - Page 36

30
4. Using Menus
3
Press the [MENU CTL] DOWN button.
The submenu “Lamp” of “Information” is displayed.
The menu item can be selected by pressing the ENTER button instead of the SELECT DOWN button
To return to the previous state, press the [MENU CTL] UP button, or the CANCEL button.
4
Press the [MENU CTL] LEFT/RIGHT button to select the submenu “Version.”
At each press of the [MENU CTL] LEFT/RIGHT button, the display will cycle as “Lamp” ←→ “Macro Key” ←→ “Usage”
←→ “Error Code” ←→ “Version” ←→ “IP Address” ←→ “MMS Status.”
5
Press the [MENU CTL] DOWN button.
The submenu “System” another rank lower than “Version” is displayed.
6
Press the [MENU CTL] DOWN button.
The submenu “BIOS” another rank lower than “System” is displayed.
7
Press the [MENU CTL] LEFT/RIGHT button to select the submenu “Data.”
At each press of the [MENU CTL] LEFT/RIGHT button, the display will cycle as “BIOS” ←→ “Firmware” ←→ “Data” ←→
“Serial No.,” and each version information is displayed.
8
Press the [MENU CTL] UP button several times.
At each press of the [MENU CTL] UP button, the display will return to a menu one level above.