NEC NEAX 2000 IPS - External; BATTM Battery Connection

CHAPTER 2 INSTALLATION
– 134 – NWA-008841-001 Rev.5.0
90ch2001.fm
External / BATTM Battery Connection
(1) Connect the BATT CA EXT cable to the batteries as shown below.
(2) Mount the battery units (24 V DC, 24 AH per unit) into the Battery Module (BATTM), if the BATTM
required.
(3) Plug the BATT CA EXT connector into the BATT1 connector on the PZ-PW121/PZ-PW126 card in
PIM0 or PIM4.
NOTE: Screws are attached to the BATTM.
Battery Mounting into BATTM
Continued on next page
BATTERY UNIT
(24 V DC, 24 AH)
BATTERY UNIT
(24 V DC, 24 AH)
BATT CA EXT
TO BATT1 CONNECTOR
ON PZ-PW121/PZ-PW126
IN PIM0/PIM4
Recommended Batteries
Yuasa NP-24-12B
Matsushita LCL-12V-24
DIMENSION OF BATTERY
175 mm
(6.9 inch)
125 mm
(4.9 inch)
165 mm
(6.5 inch)
BATTERY CONNECTION