– 288 – NWA-008841-001 Rev.5.0
90ch2002.fm
CHAPTER 2 INSTALLATION
Office Data Copy
There are two ways for office data copy as follows.
• Automatic Office Data Copy
When a Stand by MP starts:
3 to 6 minutes later after the MP card has entered into a stand by mode, all office data are copied from
the active MP card to the stand by MP card automatically.
At a Predetermined Time:
The office data is copied automatically from the active MP card to the stand by MP card at the pre-
determined time assigned by CM43 Y=4>00-03 once to four times a day.
NOTE: If you set two or more starting time for automatic office data copy, set the time with fifteen min-
utes or more intervals.
• Manual Office Data Copy
Set the data for manual office data copy as follows.
CMEC Y=5>0: 0 (start copy)
NOTE: “1” is displayed during the office data is being copied.
BACKUP CPU SYSTEM
To Next Page
Loading...
