NEC NEAX 2000 IPS - Application Processor Card

CHAPTER 1 GENERAL INFORMATION
– 23 – NWA-008841-001 Rev.5.0
90ch1001.fm
Application Processor Card
This table shows the names and functions of each application processor card.
NOTE: PN-AP01 (AP01) card and PN-CC01 (ETHER) card cannot be mounted in NEAX 2000 IPS.
Application Processor Card Name and Function
Continued on next page
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-AP00-B
[For PCS]
DBM Data Base Module Card for WCS Roaming function
One card per system.
Supports number extension of PS.
[Series 3400 software required]
PN-AP00-B AP00 Application Processor Card
Provides four RS-232C ports, and is used for SMDR, Hotel
Printer, CIS, PMS, MCI functions.
(For PMS function, PN-AP00-B with MRCA program is not
available.)
One card per system.
PN-AP00-D AP00 Application Processor Card
Provides four RS-232C ports, and is used for SMDR, Hotel
Printer, CIS, MCI functions.
One card per system.
PN-BRTA BRT 1-line Basic Rate (2B+D) Interface Trunk Card
Accommodates one 2-channel PCM digital lines.
PN-2BRTC BRT 2-line Basic Rate (2B+D) Interface Trunk Card
Accommodates two 2-channel PCM digital lines.
PN-2BRTK
[For UK]
BRT 2-line Basic Rate (2B+D) Interface Trunk Card
Accommodates two 2-channel PCM digital lines.
PN-4BRTA-A BRT 4-line Basic Rate (2B+D) Interface Trunk Card
Accommodates four 2-channel PCM digital lines.
PN-24CCTA CCT CCIS (1.5 Mbps) Trunk Card
Provides a built-in Common Channel Handler (CCH) of No.7
CCIS.
JULY/1/2006
EQUIPMENT NAME AND FUNCTION