NEC NEAX 2000 IPS - Built-In SMDR;PMS on IP (MP)

– 268 – NWA-008841-001 Rev.5.0
90ch2002.fm
Built-in SMDR/PMS on IP (MP)
[Series 3400 software enhancement]
The ETHER card (PZ-M606-A) on the MP card provides on LAN interface port for SMDR/PMS.
Connect the SMDR/PMS terminal to LAN port of the PZ-M606A-A card on the PN-CP24-A/CP24-B/
CP24-C/CP24-D card using 10BASE-T/100BASE-TX cable as shown below.
SMDR/PMS Terminal Connection
The LAN interface specifications are listed below.
NOTE: The MP card in Main site communicates with the SMDR/PMS terminal. Therefore, in the com-
munication settings in SMDR/PMS terminal side, set the IP address to connected to the address
specified by office data (CM0BY=00>00 or CM0BY=02>03), and application port number
shown in the above table.
Item Specifications
Physical layer Ethernet
Connection layer The Ethernet packet format complies with the DIX standard.
TCP/IP protocol ARP,IP,ICMP,UDP,TCP
Socket interface Complies with 4.3 BSD socket interface
Transport protocol TCP stream type protocol
Application port number SMDR: 60010 (fixed)
PMS : 60050 (fixed)
Number of connection 1
Client/Server Client : SMDR/PMS terminal
Server: PBX
Transmission code 7-bit ASCII code
Quasi-normal restriction condition 1. When connection is closed.
2. Status monitoring text
10BASE-T/100BASE-TX cable
PBX
SMDR/PMS
Switching HUB
LAN
PZ-M606-A
TO LAN PORT
PN-CP24-A
/CP24-B
/CP24-C
/CP24-D
JULY/1/2006
Built-in SMDR/PMS on IP (MP)