– 278 – NWA-008841-001 Rev.5.0
90ch2002.fm
CHAPTER 2 INSTALLATION
SYSTEM DATA ENTRY
There are two methods for data entry, using a Customer Administration Terminal (CAT)
or a Maintenance Administration Terminal (MAT).
NOTE: For assigning system data, refer to the “Command Manual”.
CAT
Any D
term
can be assigned as a CAT through programming. The D
term
can still be used as a regular tele-
phone when it is not in CAT mode. If the system is initialized by “C” (Resident System Program), every
D
term
will be able to go into CAT mode. If the system is initialized by “B” (All Clear), only LEN000 is
assigned as a CAT port (the DLC card must be installed in slot LT00).
To use a D
term
as a CAT, follow the procedures shown below.
NOTE: It is necessary to complete Steps 1 through 6 within 4 seconds.
To set CAT mode:
1. Press or
2. Press or
- CNF/Conf lamp flashes
3. Press
- CNF/Conf lamp is off
4. Press or
5. Press or
- CNF/Conf lamp flashes
6. Press
- CNF/Conf, SPKR/Speaker, FNC/Feature lamps are lit
- “CAT MODE” is displayed on the LCD
7. Press or
- “COMMAND = -” is displayed on the LCD
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
TRF Transfer
CNF Conf
*
TRF Transfer
CNF Conf
#
LNR/SPD Redial
SYSTEM DATA ENTRY
To Next Page
Loading...
