– 266 – NWA-008841-001 Rev.5.0
90ch2002.fm
RS RVS-15 CA-A/RS RVS-15S CA-A
RS RVS-4 CA-A/RS RVS-4 CA-C
RS RVS-4S CA-A/RS RVS-4S CA-C
NOTE: If the terminal does not send DTR or RTS signal, cut the signal lead marked by
×
in the D-Sub
connector (terminal side) as shown in the wiring diagram below.
See “RS-232C Connector Layout”. Page 274
05A-TXD
05B-GND
05C-DTR
06A-TXC (2)
06B-RXC
06D-TXC (1)
04B-RXD
04A-RTS
03-RXD
01-GND
06-DSR
24-TXC (1)
17-RXC
02-TXD
08-DCD
15-TXC (2)
02B-GND
03A-DSR
03B-CTS
02A-DCD
01C-LALB
07-GND
20-DTR
05-CTS
04-RTS
18-LALB
DCB A
06 TXC (1) RXC TXC (2)
05 DTR GND TXD
04 ---- RXD RTS
03 ---- CTS DSR
02 ---- GND DCD
01 LALB G
13 ----
12 ----
11 ----
10 ----
09 ----
08 DCD
07 GND
06 DSR
05 CTS
04 RTS
03 RXD
02 TXD
25 ----
24 TXC (1)
23 ----
22 ----
21 ----
20 DTR
19 ----
18 LALB
17 RXC
16 ----
15 TXC (2)
14 ----
01 GND
×
NOTE
----
----
----
----
----
---- ----
G: GROUND
RS RVS-15 CA-A/RS RVS-15S CA-A: 15 m (49.2 ft.)
×
RS RVS-4 CA-A/RS RVS-4 CA-C/
RS RVS-4S CA-A/RS RVS-4S CA-C: 4 m (13.1 ft.)
D-sub 25pin
(male)
NOVEMBER/15/2006
Built-in SMDR/MCI on RS-232C (MP)
To Next Page
Loading...
