ā 276 ā NWA-008841-001 Rev.5.0
90ch2002.fm
CHAPTER 2 INSTALLATION
(3) Fix the CARD STOPPER according to the following procedure.
STEP1: After mounting all circuit cards slide the CARD STOPPER to the left.
STEP2: Tighten the screws of the CARD STOPPER as shown below.
NOTE: When sliding the PIM CARD STOPPER, loosen all of the screws securing the PIM CARD
STOPPER and the PZ-M542/PZ-M557 card (the screws need not to be removed).
Installation of the CARD STOPPER
CARD
STOPPER
CARD
STOPPER
CIRCUIT CARD
CIRCUIT CARD
SLIDE THE CARD
STOPPER TO THE LEFT.
SCREW
SCREW
MOUNTING CIRCUIT CARDS
To Next Page
Loading...
