CHAPTER 1 GENERAL INFORMATION
– 19 – NWA-008841-001 Rev.5.0
90ch1001.fm
This table shows the names and functions of installation hardware.
Installation Hardware Name and Function
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
HANGER ASSEM (B) Wall Hanger Assembly
One HANGER ASSEM is required per PIM for Wall Mounting
Installation.
MOUNTING BRACKET Safety Mounting Bracket
Used as an overhead hanger for Floor Standing Installation. Wire,
chain or eyebolts are to be locally provided, to secure the bracket.
To be installed on the top PIM in four or more modules of stack. It
provides 1.1G shockproof construction.
19″ RACK BRACKET (A) 19-inch Rack Mounting Bracket Type A
One bracket is required for one PIM configuration.
One bracket is required for the top PIM of multiple module con-
figuration.
19″ RACK BRACKET (B) 19-inch Rack Mounting Bracket Type B
One bracket is required for the bottom module of multiple module
configuration.
I/F BRACKET ASSEM Inter Frame Bracket Assembly
Used to joint the frames in two-frame configuration, for Floor
Standing Installation.
BASE TRAY ASSEM Base Tray Assembly
One BASE TRAY is required per one frame for Floor Standing
Installation of Stationary Equipment.
EQUIPMENT NAME AND FUNCTION
To Next Page
Loading...
