ā 340 ā NWA-008841-001 Rev.5.0
90ch3003.fm
NOTE 3: Set the SW0-2 and SW0-3 as follows:
NOTE 4: Mount the BRT card which receives a source clock signals into PIM0.
CONDITIONS
BRT0 BRT1 BRT2 ---- BRT11
REMARKS
SW
0-2
SW
0-3
SW
0-2
SW
0-3
SW
0-2
SW
0-3
----
SW
0-2
SW
0-3
When one
BRT is
provided.
ON ON
MP card will receive the
clock signal from BRT0 at its
PLO0 input.
When more
than one BRT is
provided.
ON ON ON OFF OFF ON ---- OFF ON
MP card will receive the
clock signal from BRT0 at its
PLO0 input, under normal
conditions.
Should a clock failure occur
with BRT0, MP card will
switch to the PLO1 input
which gets clock from BRT1.
PN-BRTA (BRT)
To Next Page
Loading...
