NEC NEAX 2000 IPS - Page 373

– 357 – NWA-008841-001 Rev.5.0
90ch3003.fm
The figure in the SWITCH NAME column and the position of in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
Continued on next page
SW2 (Dip SW)
1
For terminating the transmitting side of
channels B1 and B2 with 100 Ω . (No.2
Circuit)
OFF
To remove the terminating resistor on
the transmitting side of channels B1 and
B2. (No.2 Circuit)
2
For terminating the receiving side of
channels B1 and B2 with 100 Ω . (No.2
Circuit)
OFF
To remove the terminating resistor on
the receiving side of channels B1 and
B2. (No.2 Circuit)
SW3 (Dip SW)
1
For terminating the transmitting side of
channels B1 and B2 with 100 Ω . (No.3
Circuit)
OFF
To remove the terminating resistor on
the transmitting side of channels B1 and
B2. (No.3 Circuit)
2
For terminating the receiving side of
channels B1 and B2 with 100 Ω . (No.3
Circuit)
OFF
To remove the terminating resistor on
the receiving side of channels B1 and
B2. (No.3 Circuit)
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
1
2
ON
ON
ON
1
2
ON
ON
ON
PN-4BRTA-A (BRT)