NEC NEAX 2000 IPS - Page 488

– 472 – NWA-008841-001 Rev.5.0
90ch3003.fm
The figure in the SWITCH NAME column and the position of in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
SW1 (Dip SW)
1 Always set to OFF
2 Always set to OFF
3 Always set to OFF
4 Always set to OFF
5 Always set to OFF
6 Always set to OFF
7 Always set to OFF
8 Always set to OFF
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
1
2
3
4
5
6
7
8
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
PN-SC01 (DCH)