– 536 – NWA-008841-001 Rev.5.0
90ch3004.fm
Switch Settings
The figure in the SWITCH NAME column and the position of in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 2: When using the firmware program of SC-3330 IPS IPADT PROG-B1 or later for the PN-8IPLA
card, you may set the Auto Negotiation ON/OFF settings by the SW0-3. When using the firm-
ware program of SC-3213 IPS IPADT PROG-A1 for the PN-8IPLA card, Auto Negotiation
function is always set to ON.
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
MB (Toggle SW)
NOTE 1
UP For make-busy
For normal operation
SW0
(Piano Key SW)
1 Not used
2 Not used
3
NOTE 2
ON
Auto Negotiation OFF
(100 Mbps [Full-Duplex] fixed)
Auto Negotiation ON
(Ethernet 10 Mbps/100 Mbps automatic
change)
4 Not used
ON
DOWN
4
3
2
1
OFF
ON
OFF
OFF
OFF
OFF
JULY/1/2006
PN-8IPLA (IP-PAD)
To Next Page
Loading...
