– 544 – NWA-008841-001 Rev.5.0
90ch3004.fm
• PZ-M632
The figure in the SWITCH NAME column and the position of in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE: When using the firmware program of SC-3150 IPS IPPAD PROG-C1 or later for the PN-
32IPLA-A card, you may set the MODE switch to 1 (Auto Negotiation OFF [100 Mbps <Full-
Duplex> fixed]). When using the firmware program of SC-3090 IPS IPPAD PROG-B1 for the
PN-32IPLA-A card, you may not set the MODE switch to 1.
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
MODE
(Rotary SW)
0-F Auto Negotiation ON
(Ethernet 10 Mbps/100 Mbps automatic
change)
1
Auto Negotiation OFF
(100 Mbps [Full-Duplex] fixed) NOTE
3
Auto Negotiation OFF
(10 Mbps [Half-Duplex] fixed)
4
Auto Negotiation OFF
(100 Mbps [Half-Duplex] fixed)
2, 5-F Not used
0
JULY/1/2006
PN-32IPLA-A (IP-PAD)
To Next Page
Loading...
