– 592 – NWA-008841-001 Rev.5.0
90ch3004.fm
Switch Settings
The figure in the SWITCH NAME column and the position of in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 2: When SW1 settings have changed, RST switch must be pushed.
NOTE 3: Use BIOS Redirect only when assisted by NEC.
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
MB (Toggle SW)
NOTE 1
UP For make-busy
For normal operation
RST (Toggle SW)
NOTE 2
Push when starting up this card, after MB switch is set
to DOWN position.
SW1
(Piano Key SW)
NOTE 2
1
ON
BIOS Redirect Utility (Key board)
NOTE 3
Normal Operation
2
ON
BIOS Redirect Utility (Floppy Drive)
NOTE 3
Normal Operation
3
ON
COM2: Use internal modem for remote
maintenance
OFF
COM2: RS-232C (For local direct con-
nection to maintenance console)
4 Not used
ON
DOWN
4
3
2
1
OFF
ON
OFF
OFF
OFF
JULY/1/2006
PZ-VM00/PZ-VM00-M (VM00)/PZ-VM10-M (VM10)
To Next Page
Loading...
