CHAPTER 1 GENERAL INFORMATION
– 46 – NWA-008841-001 Rev.5.0
90ch1001.fm
Continued on next page
*2 Either line/trunk cards or application processor cards can be mounted in the LT00/AP00-LT11/
AP11 slots of PIM0-7.
For mounting condition of PN-RTA (RTA), refer to the “In-Skin Router Installation Guide”.
*3 When using PIM for –48 V DC power supply system, the AC/DC PWR slot is used for the DC/DC
PWR slot. And the DC/DC PWR slot is not used. The other slots can accommodate the same cards
as a usual PIM.
(2) PIM for Backup CPU System
Circuit Card Mounting Slots (Backup CPU)
*1 PN-CP27-A/CP27-B (MP1) card is to be mounted in the MP01 slot.
*2 PN-CP27-A/CP27-B (MP0) card is to be mounted in the MP00 slot.
*3 Either line/trunk cards or application processor cards can be mounted in the LT00/AP00-LT10/
AP10 slots.
For mounting condition of PN-RTA (RTA), refer to the “In-Skin Router Installation Guide”.
LT00-LT10 : Line/Trunk card mounting slots
AP00-AP10 : Application Processor card
mounting slots
MP00/MP01 : PN-CP27-A /CP27-B mounting slots
VM : PZ-VM00/VM00-M/VM03-M/VM10-M
mounting slot
PFT : PZ-8PFTB mounting slot
AC/DC PWR : PZ-PW121/PW126 mounting slot
DC/DC PWR : PZ-PW122 mounting slot
LT09/AP09
LT08/AP08
LT07/AP07
LTC1
LTC0
LTC2
BWB
FRONT
AC/DC
PWR
LT10/AP10
LT00/AP00
LT01/AP01
LT02/AP02
LT03/AP03
LT04/AP04
LT05/AP05
LT06/AP06
MP01
MP00
LTC3
DC/DC
PWR
PFT
VM
*
2
PIM
(For
Backup
CPU)
*
1
JULY/1/2006
MOUNTING CONDITIONS OF CIRCUIT CARDS
To Next Page
Loading...
