NEC SL2100 - 5.10 Installing the IP4 WW-12;24 TXH-[ ] Multiline Terminals and options; 5.10.1 Connecting the IP4 WW-12;24 TXH-[ ] Multiline Terminals and options to the SL2100 system; 5.10.2 Special Notes

ISSUE 4.0 SL2100
INSTALLING THE MULTILINE TELEPHONES AND OPTIONAL TERMINALS 121
5.10 Installing the IP4WW-12/24TXH-[ ] Multiline Terminals and options
5.10.1 Connecting the IP4WW-12/24TXH-[ ] Multiline Terminals and options to the
SL2100 system
Refer to SL1100 System Hardware Manual for installing the IP4WW-12/24TXH-[ ] Multiline Terminals.
5.10.2 Special Notes
• The IP4WW-12/24TXH-[ ] Multiline Terminal can be connected according to the following terminal power factor.
Do not connect more than this value.
• The Illuminance sensor does not function when the IP4WW-12/24TXH-B Terminal connected to the SL2100
system.
• Due to Illuminance sensor does not function, the Automatic brightness control of LCD backlit cannot be controlled
when the IP4WW-12/24TXH-B Terminal connected to the SL2100 system.
Table 2-34 Terminal Power Factor
Terminal Power Factor
1 Chassis = < 38
Item
Power Factor
IP7WW-12/24TXH-[ ]1 TEL
1
IP7WW-60D DSS-[ ]1
1
Single Line Telephone
1
IP4WW-12/24TXH-[ ] TEL
1
Table 2-35 Maximum Number of Terminal installed
Terminal (Power Factor)
Maximum Number of Terminal installed
Remarks
1 Chassis
2 Chassis
3 Chassis
IP7WW-12/24TXH-[ ]1 (1)
24
48
72
IP7WW-60D DSS-B1 (1)
12
Single Line Telephone (1)
32
64
96
IP4WW-12/24TXH-[ ]TEL (1)
24
48
72