NEC SL2100 - 2.15 General Purpose;Door Unlock Relay Specifications; 2.16 External Paging Output Specifications; 2.17 BGM;ExMOH Source Input Specifications; 2.18 External Sensor Device Interface Specifications

ISSUE 4.0 SL2100
SYSTEM SPECIFICATIONS 213
2.15 General Purpose/Door Unlock Relay Specifications
Table 5-11 General Purpose/Door Unlock Relay Specifications
Item
Specification
Rated Voltage
DC 48 V Maximum
Rated Current
DC 320 mA Maximum
Contact
Normally Open
2.16 External Paging Output Specifications
Table 5-12 External Paging Output Specifications
Item
Specification
Output Impedance
600 Ω @ 1 kHz
Output Level
Nominal 250 mV (-10 dBm)
Maximum Output
400 mV RMS
2.17 BGM/ExMOH Source Input Specifications
Table 5-13 BGM/External MOH Source Input Specifications
Item
Specification
Input Impedance
High Impedance (>10 kΩ)
Input Level
Nominal 250 mV (-10 dBm)
Maximum Input
1 V RMS
2.18 External Sensor Device Interface Specifications
Table 5-14 External Sensor Device Interface Specifications
Applied Voltage during
Sensor Off
Loop Current during
Sensor On
Port Assignment
25 V
40 mA
Program 10-03-05: 1 (Read only)
* Port assignment should be set on Doorphone mode by Hard-
ware-Switch on 082U board.
The External Sensor device configuration shall be assigned by Hardware Switch and applied voltage
during sensor off is supported 25 V type only.
2.19 CPU Board LAN Port Specifications
Table 5-15 CPU Board LAN Port Specifications
Item
Specification
Standard
IEEE802.3 100Base-TX Compliant (Full Duplex only)
Access
CSMA/CD
I/F (Layer 1)
Speed: 100 Mbps Full duplex
Cable: CAT5 or better, Straight/Cross Auto Crossover