ISSUE 4.0 SL2100
INSTALLING WIRELESS DECT TELEPHONES 165
Be sure the wall material can hold the weight of the base.
1. Hold the base in its final location and mark the screw location based on the measurements shown
in Figure 2-172 Base Mounting Dimensions.
Figure 2-174 Base Mounting Dimensions
2. Insert the appropriate anchors for the wall material.
3. Insert the mounting screws into the anchors, leaving about 1/4 inch of space between the screw
head and the wall.
4. Connect the Ethernet cable and route the cord as shown in Figure 2-174 Base Mounting
Dimensions.
5. Place the base over the screw heads and slide it down into place.
6.5.3 Handset and Charger
Figure 2-175 Handset Front View provides a front view of the handset and Figure 2-176
Charger Top View provides a top view of the charger.
To Next Page
Loading...
