NEC SL2100 - 8.2 Call Forward to Voice Mail

ISSUE 4.0 SL2100
INSTALLING THE MAIN & EXPANSION CHASSIS 53
Table 2-8 Connectors of EXIFE-C1
No.
Connectors
Connectable Devices
J1
Back Plane Board
Connector on the Back Plane Board
J2 (EXP)
Expansion Connector
J1 (EXP1) or J2 (EXP2) connector on the EXIFB-C1 board of the Main Chas-
sis
1.7.3.3 Installing the EXIFE-C1 Board
Not all boards are hot swappable. Do not remove or install from the chassis
when powering up.
Do Not Power on until all installations have been completed.
1. Turn off the system power.
2. Insert the EXIFE-C1 board in the guide rail of Expansion Chassis and push it securely into position and
tighten the two screws of EXIFE board.
Screws
Figure 2-22 Insert the EXIFE-C1 Board
1.7.4 Chassis Inter-connection
1. Connect the Main Chassis and Expansion Chassis using the NEC provided CAT5 straight-through
cable, attached to the EXIFE-C1 board. The cable must pass two times (two rounds) through the
Ferrite Core and Ferrite Core must attached about 300 mm from the Main Chassis side refer to
EXIFE-C1
Guide rail