NEC SL2100 - Section 2 PROGRAMMING MODE; 2.1 Entering the Programming Mode; 2.2 Exiting the Programming Mode

ISSUE 4.0 SL2100
PROGRAMMING MODE 188
Section 2 PROGRAMMING MODE
2.1 Entering the Programming Mode
The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial #
*
#
*
.
Figure 3-4 Entering Programming Mode Display 1 (12TXH/24TXH-B1)
3. Dial the system password, then press Hold key to enter the Program Mode.
Figure 3-5 Entering Programming Mode Display 2 (12TXH/24TXH-B1)
For the details of programming, refer to the SL2100 Programming Manual. (separate issue)
2.2 Exiting the Programming Mode
1. Press Mute key several times to return to the "Program Mode" Screen.
Figure 3-6 Exiting the Programming Mode Display 1 (12TXH/24TXH-B1)
2. Press Speaker key to exit.
Figure 3-7 Exiting Programming Mode Display 2 (12TXH/24TXH-B1)
The system automatically saves the customer data to the memory which is backed up by lithium
battery.
200
11-10 WED 1:49PM
Menu Dir VM:00 CL:00
Password
Password@@@@@@@@
Base
Program Mode
Service OP1 OP2
10-01-
Time&Date Setup
Sys Config
back
Select
|01
Base
Program Mode
Service OP1 OP2
Base
Program Mode
Service OP1 OP2
200
11-10 WED 1:49PM
Menu Dir VM:00 CL:00