ISSUE 4.0 SL2100
INSTALLING WIRELESS DECT TELEPHONES 149
These procedures refer to items on the back of the DTL-RPT-2 Repeater:
Figure 2-154 Back View of the DTL-RPT-2 Repeater
During registration, the LED on the front of the repeater will blink. The table explains what the LED
blink patterns indicate.
Table 2-37 Repeater LED Patterns
The repeater is registered to a base and has a good signal from that base (or an-
other repeater registered to that base).
Slow blink (one blink per second)
Standby mode. The repeater is not registered or cannot be connected to the regis-
tered base.
Flicker (2 rapid blinks per second)
The repeater is in registration mode (it is looking for a base to register to).
To Next Page
Loading...
