Using the BIOS Update Utility C-15
■ An error indicating that the system's BIOS reprogram-
ming is not enabled or possibly that no Flash ROM is
installed. The utility cannot be used. Or, the system was
warm booted instead of cold booted. Be sure that System
Configuration switch SW1–1 is set to the OFF (enable)
position. Contact technical support or your NEC dealer
for update information.
■ A message indicating that the update is in progress. You
should not disturb the system in any way while this
screen appears. The system resets after the update com-
pletes. (Make sure you cold booted on AC power.)
■ An error noting that your system does not have enough
RAM available. Make sure you booted the system from
the BIOS Update diskette.
■ A message stating that the diskette you are about to use
has already been used. You may not be able to restore
the previously installed BIOS if you proceed with the
update. This condition is acceptable if you maintain a
separate copy of the utility diskette for each system.
■ An error indicating that you are attempting to restore the
original BIOS before installing the new BIOS. You must
first install the new BIOS.
To Next Page
Loading...
