Adding Options 3-13
EXTERNAL DEVICES
You can connect external devices like parallel and serial
printers, a keyboard, monitor, or mouse to your Versa P.
TIP: Be sure you have set up the external device
correctly before connecting it to your system. Follow
the setup instructions that came with the device.
Parallel Devices
To install a parallel device, you need a cable with a male
25-pin connector for the system and, for most parallel print-
ers, a Centronics®-compatible 36-pin connector.
NOTE: Before you connect a printer, be sure you
have installed the appropriate printer driver through
the Windows Control Panel.
To connect a parallel device to your Versa P, do the
following.
1. Check that both the Versa and device power are off.
2. Open the left-rear cover of the system and locate the
printer port.
3. Align and connect the 25-pin printer cable connector to
the parallel port on the system. (The parallel printer port
is the fourth from the left.) Secure the cable with the
screws provided.
To Next Page
Loading...
