5-12 Using Auto Setup
System
The System option (S) lets you set the following system
parameters.
■ Quick Boot
■ Setup Lock
The Quick Boot option removes certain tests from POST to
reduce the time needed to boot the system.
The Setup Lock option is a security feature which, when set
to disable, keeps unauthorized users from changing system
parameters at power on.
NOTE: To enable Auto Setup after disabling it, you
must use the ENABLACU.EXE utility. At the MS-
DOS prompt, type enablacu. Turn the system off
and back on again. Press F1 in enter Auto Setup.
Time/Date
Use this option (T) to set the current time and date. The set-
tings remain in memory even after you turn off system
power.
To set the time, enter the current hour, minute, and second
in hh:mm:ss, 24-hour format. For example, type
13:30:00
for 1:30 p.m.
To set the date, enter the current day, month, and year in
dd/mm/yyyy format.
TIP: When setting the time and date, enter preced-
ing zeroes. For example, to enter 9:20 a.m. and
February 4, 1994, type 09:20:00 and 02/04/1994.
To Next Page
Loading...
