5-8 Using Auto Setup
Comms
The Comms option (C) lets you check or change settings for
the parallel and serial ports.
The Comms menu lets you change the input/output (I/O)
address for the parallel or serial port. Change the default
address and interrupt level only if there is a conflict between
optional board settings. Comms also allows you to set the
mode of the parallel port.
NOTE: Use the default settings whenever possible.
Change these settings only if your system condi-
tions require different settings.
For system security, you can disable a port entirely by
selecting the “Disable” setting. This prevents unauthorized
data transfer through the port.
Drives
The Drives option (D) lets you check or change parameters
for your diskette drives and hard disk, including security
features.
Unless you are connecting the Versa P to a docking station
equipped with additional diskette drives or hard drives, you
do not need to change Diskette Drive or Hard Disk Drive
parameter settings. If you install another hard disk drive
type, you need to enter Auto Setup to accept the new sys-
tem configuration.
To Next Page
Loading...
