Nederman FlexPAK 800 User Manual

FlexPAK 800/1000
EN
24
6.1.1 Nederman FlexPAK O (O mode)
The unit is in O mode, which is also the unit’s start menu. The unit can also go into O
mode if something is wrong, such as if an alarm is acvated. The pump motor is o, there is
no vacuum, the FCV is closed, and the unit cannot be acvated by a pilot signal.
TimeToService: The amount of me unl next scheduled service. The
default seng is 2000 hours.
6.1.2 FlexPAK Standby (Standby mode)
The unit is in Standby mode. The pump motor is o, there is no vacuum, the FCV is closed,
and the unit is waing for a pilot signal to go into Running mode.
ESC OK
NEDERMAN
FLEXPAK
Standby
Waing For
Pilot Signal
Mo 15:33
6.1.3 Running (Running mode)
The unit in Running mode. The pump motor is on and the unit generates a vacuum. The
FCV is closed. The current vacuum of the unit is shown on the display, for example, -20 kPa.
ESC OK
Running
kPA -20
DIRTm 00:00 s
OTTmr 00:00 h
Exhaust
Air Temp 60°C
DIRTm: The amount of me before the unit goes into Idling mode. The
default is 10 seconds.
OTTmr: If the Overme mer has been acvated, OTTmr shows the
elapsed me since the overme mer started.
6.1.4 FlexPAK Idling (Idling mode)
The unit in Idling mode. The pump motor is on, there is no vacuum, and the FCV is open.
The unit goes into Idling mode when there has been no pilot signal for the me set in DIR_
Time.
ESC OK
FlexPak
Hi Vacuum Unit
IDLING
Time To StandBy
05:33m
TimeToStandby: The amount of me unl the unit goes into Standby
mode. The default seng is 12 minutes.
6.1.5 Filter Cleaning
The unit is cleaning its main lter.
ESC OK
Filter
Cleanining
Cycles 1
Elapsed 0
Clean 00:00 s
Charge 00:00 s
Cycles: How many cleaning pulses will be carried out.
Elapsed: How many cleaning pulses are made.
Clean: Remaining me for cleaning pulse.
Charge: Remaining vacuum build me; the me unl cleaning pulse is
acvated.
6.2 Warning messages
If a warning is acvated, there is a problem that needs to be corrected, but the unit
connues to work. If a warning message is displayed in the PLC display, the light in the

Nederman FlexPAK 800 Specifications

General

Brand	Nederman
Model	FlexPAK 800
Category	Dust Collector
Language	English