Nederman FlexPAK 800 User Manual

FlexPAK 800/1000
EN
26
6.3 Alarms
If an alarm is acvated, the unit goes into O mode unl the problem is corrected.
If an alarm message is displayed in the PLC display, the light in the Standby/Running
buon ashes one second on, one second o. This 1/1 on/o sequence connues unl
the problem is corrected and the alarm reset. See also the PLC Sengs Manual and the
Installaon and Service Manual.
6.3.1 External Fire Alarm Explosion Detected
NOTE! Establish procedures to follow in order to prevent this alarm from being acvated,
and for when the alarm is acvated. Procedures should follow the current ATEX direcve as
well as local rules and regulaons.
An external re alarm is acvated or a Relief Panel Sensor (RPS) is connected and has
detected an explosion. Press the green OK buon
OK
to reset the alarm.
6.3.2 Emergency Stop Acvated
If this message appears in the display, one or more emergency stops have been acvated
and the machine has been switched o.
Find out why the emergency stop has been acvated and correct the problem. When all
hazards have been eliminated that acvated the emergency stop, the emergency stop can
be reset. Press the green OK buon
OK
to reset the Emergency Stop Buon.
For more informaon, see the PLC Seng Manual and the Installaon and Service Manual.
6.3.3 Low Pressure or Duct Isolaon Released
The Compressed Air Switch (CAS) indicates that the compressed air pressure is too low.
Check that the compressed air supply is aached to the unit. Reconnect the compressed air
supply if necessary. If the compressed air supply is connected correctly but the compressed
air supply is too low, see the PLC Sengs Manual and the Installaon and Service Manual.
Press the green OK buon
OK
to reset the alarm.

Nederman FlexPAK 800 Specifications

General

Brand	Nederman
Model	FlexPAK 800
Category	Dust Collector
Language	English