Nederman FlexPAK 800 User Manual

FlexPAK 800/1000
25
EN
Standby/Running buon ashes one second on, one second o. This 1/1 on/o sequence
connues unl the problem is corrected. See also the PLC Sengs Manual and the
Installaon and Service Manual.
NOTE! There are two excepons to this rule, Secons ‘10.3.1 Time For service’ and
‘6.2.2 Bag Replacement Switch Acvated’.
6.2.1 Dustbin Full
The Bin Level Indicator has detected that the dust bin has been full for 12 minutes. Empty
the dust bin and press
OK
to reset the warning.
ESC OK
Warning!
D u s t b i n F u l l
Th 15:01
Time To Unit
Stop 05:00 m
Reset OK 
Clean: Remaining me for cleaning pulse.
Charge: Remaining vacuum build me. The me unl the cleaning pulse
is acvated. Charge = Vacuum building me (Charge me).
Pulse: How many cleaning pulses are made of 3.
6.2.2 Bag Replacement Switch Acvated
The bag replacement switch (SC2) is acvated. It shows the maximum allowed me to
replace the dust bag, and how much me is le to replace the dust bag and turn o the
bag replacement switch before the unit is put into O mode.
If this warning is acvated, the light in the Standby/Running buon is lit for two seconds
and then again in 2 seconds. This 2/2 on/o sequence connues unl the warning is reset.
ESC OK
Bag Replacement
Switch Activated
Time to Unit
Stop 02:00m
Max Time 30:00m
Stop: The remaining me to replace the dust bag before the unit is put
into O mode.
MaxTime: The maximum amount of me allowed to replace the dust
bag.

Nederman FlexPAK 800 Specifications

General

Brand	Nederman
Model	FlexPAK 800
Category	Dust Collector
Language	English