To enable VPN pass-through:
1.
Enter http://mywebui.net or http://192.168.1.1.
A login page displays.
2. Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
3. Select Settings > Other > VPN Passthrough.
The ROUTER SETUP page displays.
4. Select the VPN Passthrough On radio button.
The default selection is AUTO.
Specify the IP Addresses That the Mobile
Router Assigns
By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The
router assigns IP, DNS server, and default gateway addresses to all computers connected
to the LAN. The assigned default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router’s LAN IP
address. Using the default addressing scheme, define a range between 192.168.1.2
and 192.168.1.254, although you can save part of the range for devices with fixed
addresses.
To specify the pool of IP addresses that the mobile router assigns:
1. From a computer that is connected to your network, launch a web browser.
2.
Enter http://mywebui.net or http://192.168.1.1.
A login page displays.
3. Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4. Select SETTINGS > Setup > Mobile Router Setup.
The ROUTER SETUP page displays.
5. Enter the starting IP address and the ending IP address.
6. Click the Apply button.
User Manual58Specify the Mobile Router
Network Settings
Nighthawk M5 5G WiFi 6 Mobile Router
To Next Page
Loading...
Need help?
General
