Advanced Settings
100
R6300v2 Smart WiFi Router
To set up the router as an AP:
1. Connect an Ethernet cable to the Internet port of this router and to a LAN port in the
other router
.
Cable this port to a LAN port
on the other router
2. Select ADVANCED > Wireless AP.
3. Select the Enable Access Point Mode check box.
The screen adjusts.
4. (Optional) If you want to manually assign a specific IP address to this router while it is in
AP
mode, select the enable fixed IP setting on this device (not recommended) check box.
5. Click the Apply button.
The IP address of the router changes, and you are disconnected. To reconnect, close
and restart your web browser
, and type http://www.routerlogin.net.
To Next Page
Loading...
