Advanced Settings
111
R6300v2 Smart WiFi Router
• If your Internet connection does not use PPPoE, DHCP, or fixed, but is IPv6, select
Auto Config.
For more information about Internet connection types, see the following sections.
3. Click the Apply button.
Your changes take effect.
Requirements for Entering IPv6 Addresses
IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by
colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero
or altogether omitted.
The following errors invalidate an IPv6 address:
• More than eight groups of hexadecimal quartets
• More than four hexadecimal characters in a quartet
• More than two colons in a row
Auto Detect
To set up an IPv6 Internet connection through auto detection:
1. Select ADV
ANCED > Advanced Setup > IPv6.
The IPv6 screen displays.
2. In the Internet Connection
Type list, select Auto Detect.
The screen adjusts:
The router automatically detects the information in the following fields:
• Connection T
ype. This field indicates the connection type that is detected.
• Router
’s IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the router’s WAN (or Internet) interface. The number after the slash (/) is the
To Next Page
Loading...
Need help?
General
