NETGEAR R6300v2 User Manual

ReadySHARE Printer
66
R6300v2 Smart WiFi Router
Set Up the NETGEAR USB Control Center
The first time you access the utility, you are asked to select the printer.
• When a USB printer is detected and connected automatically during the initial setup, you
have to disconnect the printer and wait for the prompt asking you to click Connect.
• Y
ou might be asked to install the driver for this printer. After the driver is installed, the
printer status changes to Available.
 To set up the NETGEAR USB Control Center:
1. On each computer on your network that shares the USB printer
, launch the NETGEAR
USB Control Center the same way you launch any application program on your
Windows or MAC computer.
2. Select the printer and click the Connect button.
Once the connection is established, the status changes to Manually connected by xxx.
3. Click the Disconnect button.
The status changes to Available.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)