NETGEAR R6300v2 User Manual

Advanced Settings
115
R6300v2 Smart WiFi Router
IPv6 Pass Through
In pass-through mode, the router works as a Layer 2 Ethernet switch with two ports (LAN and
WAN Ethernet ports) for IPv6 packets. The router does not process any IPv6 header
packets.
 To set up a pass-through IPv6 Internet connection:
1. Select ADV
ANCED > Advanced Setup > IPv6.
The IPv6 screen displays.
2. In the Internet Connection
Type list, select Pass Through.
The screen adjusts, but no additional fields display.
3. Click the Apply button.
IPv6 Fixed
 To set up a fixed IPv6 Internet connection:
1. Select ADV
ANCED > Advanced Setup > IPv6.
The IPv6 screen displays.
2. In the Internet Connection
Type list, select Fixed.
The screen adjusts:
3. Configure the fixed IPv6 addresses for the WAN connection:
• IPv6 Address/Prefix
Length. The IPv6 address and prefix length of the router WAN
interface.
• Default IPv6 Gateway.
The IPv6 address of the default IPv6 gateway for the router’s
WAN interface.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)