NETGEAR R6300v2 User Manual

USB Storage
49
R6300v2 Smart WiFi Router
USB Drive Requirements
The router works with most USB-compliant external flash and hard drives. For the most
up-to-date list of USB drives that the router supports, go to:
http://kbserver.netgear.com/readyshare
Note:Some USB external hard drives and flash drives require you to load the drivers onto the
computer before the computer can access the USB device. Such USB devices do not work
with the router
.
The router supports the following file system types for full read/write access:
• FAT16, FAT32
• NTFS
• NTFS with compression format enabled
• Ext2, Ext3, Ext4
• XFS
• HFS
• HFS+
Note: HFS+ Journal is read only because Time Machine is not supported in
this router. For more information about Time Machine, visit
www.netgear.com/readyshare or see your Mac’s documentation.
Connect a USB Storage Device to the Router
ReadySHARE lets you access and share a USB drive connected the router USB port. If your
USB device has special drivers, it is not compatible.
 To connect a USB storage device:
1. Insert your USB storage device into the USB 3.0 port on the back of the router
.
USB 3.0 port

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)