NETGEAR R6300v2 User Manual

Administration
93
R6300v2 Smart WiFi Router
Erase the Current Configuration Settings
You can use the Erase button to erase the configuration and restore the factory default
settings. You might want to erase the settings if you move the router to a different network.
You can also use the Reset button on the back of the router to erase the configuration and
restore the factory settings. (See Factory Settings on page 132).
 To erase the configuration settings:
1. Select ADV
ANCED > Administration > Backup Settings.
2. Click the Erase button.
The factory default settings are restored. The user name is admin, the password to
password, and the LAN IP address is 192.168.1.1. DHCP is enabled.
Change the Password
This feature lets you change the default password that is used to log in to the router with the
user name admin.
Changing this password is not the same as changing the password for wireless access. The
label on the bottom of your router shows your unique wireless network name (SSID) and
password for wireless access (see Label on page 10).
 To set the password for the user name admin:
1. Select ADV
ANCED > Administration > Set Password.
2. Type the old password, and type the new password twice.
3. If you want to be able to recover the password, select the Enable Password Recovery
check box.
4. Click the Apply button.
Your changes take effect.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)