NETGEAR R6300v2 User Manual

USB Storage
55
R6300v2 Smart WiFi Router
USB Storage Device Network and Access Settings
You can set up the device name, workgroups, and network folders for your USB device.
 To view or change the USB storage advanced settings:
1. Select ADV
ANCED > USB Storage > Advanced Settings.
2. Specify access to the USB storage device.
• Network Device Name.
The default name is readyshare. This name is used to
access the USB device connected to the router.
• W
orkgroup. If you are using a Windows workgroup rather than a domain, the
workgroup name is displayed here. The name works only in an operating system that
supports NetBIOS, such as Microsoft Windows.
• Access Method. Select the check boxes for the access methods that you want.
- Network Neighborhood/MacShare. Enabled by default.
- HTTP. Enabled by default.
You can type
http://readyshare.routerlogin.net/shares to access the USB drive.
- HTTP (via Internet). Disabled by default. If you enable this feature, remote users
can type http://<public IP address/shares> (for example,
http://1.1.10.102/shares) or a URL domain name to access the USB drive over the
Internet.
This feature supports file uploading only.
- FTP. Disabled by default.
- FTP (via Internet). Disabled by default. If you select this check box, remote users
can access the USB drive through FTP over the Internet.
This feature supports
both downloading and uploading of files.
3. If you changed the settings, click Apply.
Your changes are saved.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)