ReadySHARE Printer
70
R6300v2 Smart WiFi Router
Launch the NETGEAR USB Control Center
The NETGEAR USB Control Center shows the availability status of the USB devices. The
NETGEAR USB Control Center utility must be running for the computer to be able to print to
the USB printer attached to the router. If you exit the utility, printing does not work.
To launch the NETGEAR USB Control Center:
Launch the NETEAR USB Control Center the same way you launch any application
program on your Windows or MAC computer
.
The main screen shows a device icon, the description for this USB device, and its status.
• A
vailable. The device is available from the computer that you are using.
• W
aiting to Connect. You need to connect to this device from the computer that you are
using. The first time you connect, you might be prompted to install the device driver.
The following menu selections display:
• System. Exit the utility
.
• T
ools. Access the Control Center - Configuration screen to set up your shared USB
device. For more information, see Configure the NETGEAR USB Control Center on
page 67.
• About. V
iew details about the USB Control Center software.
The following control buttons are available:
• Connect.
The first time you access the utility, you are asked to select the printer and click
the Connect button.
• Disconnect. Click the Disconnect button at any time to release the connection.
• Network Scanner.
This button activates the scanner window so that you can use the
printer for scanning. Your printer must support scanning and be in the Available state.
To Next Page
Loading...
Need help?
General
