NETGEAR R6300v2 User Manual

NETGEAR genie Basic Settings
28
R6300v2 Smart WiFi Router
 To set up a guest network:
1. Select BASIC > Guest Network.
2. Select any of the following wireless settings:
Enable Guest Network. When this check box is selected, the guest network is enabled,
and guests can connect to your network using the SSID of this profile.
Enable SSID Broadcast. If this check box is selected, the wireless access point
broadcasts its name (SSID) to all wireless stations. Stations with no SSID can adopt the
correct SSID for connections to this access point.
Allow guest to access My Local Network. If this check box is selected, anyone who
connects to this SSID has access to your local network, not just Internet access.
3. Give the guest network a name.
The guest network name is case-sensitive and can be up to 32 characters. You then
manually configure the wireless devices in your network to use the guest network name in
addition to the main SSID.
4. Select a security option from the list.
The security options are described in Wireless Security Options on page 26.
5. Click the Apply button.
Your settings are saved.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)